Sensor Models

IMU, GPS, RADAR, ESM, and EO/IR

Model various sensors, including: IMU (accelerometer, gyroscope, magnetometer), GPS receivers, altimeters, radar, lidar, sonar, and IR. You can mimic environmental, channel, and sensor configurations by modifying parameters of the sensor models. For active sensors, you can also model the corresponding emitters and channels as separate objects.

Functions

expand all

Altimeter

altimeterSensor Altimeter simulation model

GPS

gpsSensor GPS receiver simulation model

IMU

`imuSensor`	IMU simulation model
`accelparams`	Accelerometer sensor parameters
`gyroparams`	Gyroscope sensor parameters
`magparams`	Magnetometer sensor parameters
`allanvar`	Allan variance
`magcal`	Magnetometer calibration coefficients
`transformMotion`	Compute motion quantities between two relatively fixed frames

Infrared

`irSensor`	Generate infrared detections for tracking scenario
`irSignature`	Infrared platform signature

INS

insSensor Inertial navigation system and GNSS/GPS simulation model

Radar

`fusionRadarSensor`	Generate detections and tracks reports
`radarChannel`	Free space propagation and reflection of radar signals
`radarEmission`	Emitted radar signal structure
`radarEmitter`	Radar signals and interferences generator
`rcsSignature`	Radar cross-section pattern

Lidar

`monostaticLidarSensor`	Simulate and model lidar point cloud generator
`extendedObjectMesh`	Mesh representation of extended object
`tracking.scenario.airplaneMesh`	Mesh representation of airplane

Sonar

`sonarEmission`	Emitted sonar signal structure
`sonarEmitter`	Acoustic signals and interferences generator
`sonarSensor`	Generate detections from sonar emissions
`tsSignature`	Target strength pattern
`underwaterChannel`	Propagated and reflected sonar signals

Broadcast System

`adsbCategory`	Enumeration of Automatic Dependent Surveillance-Broadcast categories
`adsbTransponder`	Automatic Dependent Surveillance-Broadcast (ADS-B) transponder
`adsbReceiver`	Automatic Dependent Surveillance-Broadcast (ADS-B) receiver

Blocks

GPS	Simulate GPS sensor readings with noise
IMU	IMU simulation model
INS	Simulate INS sensor

Topics

Introduction to Statistical Radar Models for Object Tracking
In a tracking system, sensors are used to generate measurements or detections from targets in an environment.
模拟Radar Detections
Simulate target detections by radar sensors.
Model IMU, GPS, and INS/GPS
Model combinations of inertial sensors and GPS.
Introduction to Simulating IMU Measurements
This example shows how to simulate inertial measurement unit (IMU) measurements using theimuSensorSystem object.
Remove Bias from Angular Velocity Measurement
This example shows how to remove gyroscope bias from an IMU usingimufilter.

Featured Examples

Scanning Radar Mode Configuration

Model different radar scan modes using thefusionRadarSensor. This example shows how to configure thefusionRadarSensorfor several commonly used radar scan modes. With this model, you can simulate radars which mechanically scan, electronically scan, and which use both mechanical and electronic scanning. The scan limits in azimuth and elevation are configurable for both mechanical and electronic scan modes.

Open Script

Generate Off-Centered IMU Readings

Generate inertial measurement unit (IMU) readings from a sensor that is mounted on a ground vehicle. Depending on the location of the sensor, the IMU accelerations are different.

Open Live Script